Each extension can be pre-set to ring at a pre-determined
time. This time can be set in two ways, one is
program the complete time and other is program
minutes up to 99. in second case extension will
get ring after the programmed minutes from current
time.
This
can be done as follows,
Lift
Handset and on getting system dial tone,
Dial
and hang up.
where,
AM=0/PM=1
HH=HOURS (2 digits must be used)
MNT=MINUTES (2 digits must be used)
The
extension will ring at the appointed time. On
lifting the receiver the user will hear music.
HH stands for hours MM stands for minutes.
For
example, if the alarm is to be set for 3.15 PM
then,
Dial
and hang up.
In
case the extension is in use at 3.15 PM the alarm
will ring after you go on hook. MM should be rounded
off to nearest 0 or 5 i.e. 3.13 to 3.15 and 3.12
to 3.10.
Setting
of Reminder Call
This
can be done as follows,
Lift
Handset and on getting system dial tone,
Dial
and hang up
where,
MNT=MINUTES (2 digits must be used)
It
is similar to alarm call but here instead of time
one has to dial minutes from 01 to 99. The extension
will ring after that time period is over from
when the call was registered.
For
example, If you want a reminder call after 30
minutes from now,
Dial
and hang up.
|
