| |
This program will set waiting period for incoming
call after Voice Guidance Message is over. When
the period is set to zero second, the system will
not accept any dialing by the caller even when
Voice Message is played and once the message is
over, the call will get transferred to programmed
extension as per the programming of day or night
mode ring termination. This zero second time is
used when user only wants to give welcome message
to the caller and do not want caller to dial extension
number. The timings can be independently programmed
for both voice guidance chip when dual voice guidance
is used in the system. The timings can be 1 second
to 9 second as per the Voice Guidance Chip.
To program this, dial as follows,
Password
+
and hang up.
Where,
C is 0/1/2 For any chip/chip-1/chip-2 respectively,
S is Timings in Seconds 0-9 seconds.
For
example, Voice Chip-1 is to be programmed
for welcome message and voice Chip-2 for general
purpose with delay of 5 seconds for user to dial
extension number then program as follows,
Password
+
Listen Dial Tone and now for second chip Continue
as,
and hang up.
Note:
Remember, the caller can dial extension number
while Voice Message is played and system will
accept dialing, if timing programmed are not zero
and telephone line is in good condition and not
inserting any substantial losses in transmission.
The Voice Message Chip can have recording time
up to 45 seconds but the exchange will insert
pause of the programmed timing, for transferring
the call, once the message is over even if message
is just 5 seconds length. That means with a message
of 5 Seconds and delay time programmed as 5 Seconds,
and if caller does not dials any number, the call
will come to default extension on 10th second.
For message of 30 seconds, the call will come
to default extension after 35 seconds in same
situation. |
|
