|
The User Programming Password is different from
User Personnel Password and System Programming
Password. To program any of the user system programming,
user must enter User or System Programming Password.
The extension will remain in programming mode
till programmer hangs of cradle completely exceeding
flash time or otherwise programmer can proceed
without re-entering password by just flashing
on busy-tone or else. The default User Programming
Password is 5678.
To enter in to programming password dial as follows,
and system tone.
Where
PPPP is User Programming Password.
If you do not get system tone then password is
wrong or any other extension is in programming.
Note:
The User Programming password should be different
from User Personnel Password and System Programming
Password.
|
