| |
The DISA feature is highly flexible with lot of
option for both day and night mode and each mode
can have different set of parameters. The DISA
is disabled automatically when STD detect on trunk
is enabled, without or with CLID (CLID Local table
programmed) and the received call is STD call.
The DISA is also disabled when the received call
identified by CLID table as a specified one in
table and the call will terminate directly to
specified extension provided extension is not
busy or do not disturb not set on that extension.
The DISA for individual Day or Night Mode and
for individual trunk can be configured, without
voice guidance in Basic SECOM series and with
voice guidance port-1 or voice guidance port-2
or any free voice guidance port, having voice
guidance card attached to the system. The DISA
with Voice Message, if programmed along with Call
termination after voice guidance over (Code 462)
with zero wait period, no DTMF dialing will be
accepted, which can be used for giving only welcome
message on a Trunk line, disabling DISA.
To disable the DISA program as follows,
Password
+
To
Enable DISA program as follows,
Password
+
For
MS Series DISA is always without Voice Guidance
and program as follows,
Password
+
This
will Enable DISA in MS Series.
Where,
M(Mode) is 0/1 for Day Mode / Night Mode,
*/Trk is * for All Trunk and Trk is Particular
Trunk,
T is type for DISA as follows,
T=0 - DISA without Voice Guidance
T=1 - DISA with Voice Guidance Port 1
T=2 - DISA with Voice Guidance Port 2
T=3 - DISA with any available Voice Guidance Port
For example,
DISA on 27 Trunk with Voice Port-2, DISA on 28
without Voice Guidance and on Trunk 29 without
DISA is required during Day mode then programme
as follows,
Password+
Here
Voice Port-1 is not used and can be either used
for Night Mode Voice Message or for Security Break
Alert for Auto Dialer message. |
|
